Setting up your dtv, Closed caption, Favorite channel list – Hitachi 37HDL52A User Manual
Page 44
43
English
SETTING UP YOUR DTV
To change password, enter the Change Password Number option in PASSWORD function and press SEL button to change password.
Enter four digital password in enter new password number. And then confirm the password by entering the same password again.
This function allows to reset receiver back to factory default status.
1.Press ▲▼ buttons to highlight the “Reset Default”, and then press SEL to into the rating control menu.
2. There will pop up the RESET confirmation message “Press Yes to restore default value”. Press SEL on “Yes” to process. Press SEL
on “NO” to cancel the setting.
CLOSED CAPTION
1. When you learn from the I-PLATE that there is Closed Caption data on the current channel, you can press
CC button on the remote control to display C.C. Option list it on the TV screen.
2. Use ▲ and ▼ buttons to highlight the desired CC signal and press SEL button.
3. After the type of Closed Caption has been selected, press EXIT or CC buttons to cancel the CC Option list,
then you can watch this Digital TV program with Closed Caption.
FAVORITE CHANNEL LIST
1. When you are watching terrestrial or cable TV channels, you can
press “FAV” button on the remote control to call up the Favorite List.
2. Use W and X buttons to navigate “ALL”, “ATSC”, and “CABLE”
program lists.
3. Use ▲ and ▼ buttons to browse through the selected program
lists and highlight the program you like to watch, then press SEL
button.
Change Password
Reset Default
NOTES: 1. Before you change the password, use the default password “0000” to enter the Menu item which requires the
password.
2. If you forget the password, please use the password “1234” to enter.
3. To enter the new password, and follow the instruction.
NOTE: Press Numeric Key to Select Digital Channel
For the digital channel number is different with the traditional NTSC channel number. Please follow below indication to
select the digital channel if you prefer using numeric key doing the channel selection.
Example: digital channel number: 10 - 2
1. Press numeric key “1” and “0”
2. Press “X“button
3. Press numeric key “2”