GE CGS980 - Manual (Page 32)

Turn all controls OFF before removing the
burner parts.
The round side burner caps and burner
heads can be lifted off, making them easy to
clean. The electrodes are not removable.
The oval center burner head and cap
assembly can be lifted off, making it easy
to clean. The burner electrode is not
removable.
CAUTION:
Do not operate the
cooktop without all burner parts and grates in place.
Operating Instructions
Safety Instructions
Installation Instructions
Tr
oubleshooting T
ips
Consumer Support
32
Be sure electrical power is off and all surfaces are cool before cleaning any part of the range.
If your range is removed for cleaning, servicing or any reason, be sure the anti-tip device
is re-engaged properly when the range is replaced. Failure to take this precaution could
result in tipping of the range and cause injury.
Care and cleaning of the range.
Sealed Burner Assemblies
Burner head
and cap
assembly
Center
griddle
Electrode
Electrode
Burner cap
Burner head
Burner base
Front right burner
Make sure the hole in the burner
head is positioned over the electrode
and that the burner head is fully
inserted inside the burner base.
A small gap between the base and
head is normal.
Electrode
Burner cap
Stability
chamber
Burner base
Front left burner, back right burner
and back left burner
Make sure the slot in the burner head
is positioned over the electrode.
Burner head
Use a sewing
needle or
twist-tie to
unclog the
small hole in
the burner
head.
The electrode of the spark igniter is
exposed when the burner head is
removed. When one burner is turned
to LITE, all the burners spark. Do not
attempt to disassemble or clean
around any burner while another
burner is on. An electric shock may
result, which could cause you to knock
over hot cookware.
Electrode
Electrode
Burner head
Burner base
Front right burner
Front left, back right
and back left burner