Grizzly ULTIMATE 14" G0555P - Manual (Page 13)

model g0555/g0555p (mfg. Since 5/11)
-11-
voltage conversion
the voltage conversion mUSt be performed by
a electrician or qualified service personnel. to
perform the voltage conversion, install the cor-
rect plug and rewire the motor to the new volt-
age, according to the provided wiring diagram on
Page 56.
Note: If the diagram included on the motor con-
flicts with the one in this manual, the motor may
have changed since the manual was printed. Use
the diagram provided inside the motor wiring junc-
tion box.
To convert the machine to 220v:
1. diSConneCt mAChine From poWer!
2. replace the 5-15 plug on the power cord with
a 6-15 plug.
3. re-wire the motor as illustrated in the wiring
diagram.
Extension cords
We do not recommend using an extension cord
with this machine. If you must use an extension
cord, only use it if absolutely necessary and only
on a temporary basis.
Extension cords cause voltage drop, which may
damage electrical components and shorten motor
life. Voltage drop increases as the extension cord
size gets longer and the gauge size gets smaller
(higher gauge numbers indicate smaller sizes).
Any extension cord used with this machine must
contain a ground wire, match the required plug
and receptacle, and meet the following require-
ments:
Minimum Gauge Size ...........................14 AWG
Maximum Length (Shorter is Better).......50 ft.