Motorola APS120 - Manual (Page 67)

D • 2
Select Transmitter Type
You must select the PCI Local Wi reless Paging Transmitter Type. Select XMT#2 on the PBX
Parameters Screen (Figure 3-4).
NOTE: Do not enable Carrier Detect.
Pagers
When you send a paging message command to the Transmitter unit from the APS
Custom, the green TX indicator on the Transmitter Unit should illuminate for a few
seconds to indicate that transmission is occurring. If you don't receive a message on
the selected paging receiver, follow the checklist below to troubleshoot the paging
reception:
1. Verify that the pager is turned on.
2. Verify that the pager has a fresh battery.
3. Verify that you have selected the proper Pager ID number when calling the
APS Custom.
4. Verify the proper CAP code setting for the Pager ID.
5. Verify that the pager is located at least 10 feet away from the Transmitter
Unit during transmission. (Some paging receivers do not properly decode
paging messages when the paging receivers are located in close proximity
to the transmitter antenna. Holding a paging receiver 10 feet away from
a transmitter antenna is usually sufficient to allow the paging receiver to
properly decode a paging transmission.)
6. Verify that the antenna is attached to the
transmitter unit.
7. Verify that the pager is at the same frequency
as the Paging System Transmitter. (Both the
pagers and the transmitter have labels which
provide frequency information.)