Motorola D210 - Manual (Page 27)

25
English
2. Press or to take the external call.
Transferring a call
You can transfer an external caller from your handset to
another internal handset.
During an external call:
1. Press
. The external caller is put on-hold.
2. Enter the number of the handset you want to transfer a call
with using the number keypad.
3. When the called handset answers, press or place the
handset back on the base to transfer the call.
If the called handset does not answer, press to return to
the external caller.
Conference call
You can hold a 3-way conversation (conference call) between
your handset, an external caller and another internal handset
user.
During an external call:
1. Press
. The external caller is put on-hold.
2. Enter the number of the handset you want to have a
conference call with using the number keypad. The called
handset will ring.
3. When the called handset answers, press on the
initiating handset to start your conference call.
4. Any handset can press at any time to leave the
conference call.
15. Simple solutions
The most common problems often have the simplest
solutions. We hope that you will not experience any problems
with your product, but in the event that you do, this section
hopes to overcome any problems quickly and with minimum
effort.
Firstly, check that:
• the telephone line cord is correctly connected.
• the mains power cord is correctly connected and switched
on.
• the batteries are charged and not in need of replacing.
If you have more than one handset registered to your base
remember to check the connections on these too.
If you are still experiencing a problem, you are likely to find a
solution below.
Handset/Base
No dial tone
• Is the handset registered to the base? - see page 20.
• Is the symbol flashing and can you hear a beep during a
call? - if so, move closer to the base as you are out of
range.
Cannot dial out
• Is symbol displayed? - if so, the keypad lock is on, see
page 11.
Handset does not ring
• The ringer volume may be set to off. - see page 18.
• Is the symbol flashing? - if so, move closer to the base
as you are out of range.
Handset is not charging properly
• Check that the charge light is on and that the handset is
sitting correctly in the base. Clean the charging contacts
with a dry cloth.
Allegro_CID TAD.book Page 25 Tuesday, January 15, 2008 4:30 PM