MITSUBISHI ELECTRIC HS-HD1100U - Manual (Page 18)

16
Adding and Deleting Channels
If necessary, you can manually add or delete channels after you have completed
the automatic channel memorization.
1 Make sure that video mute is ON. See page 47.
2 Set the VCR’s input to Tuner. To do this, press INPUT on the remote control
until a channel number appears on the screen or the front panel display.
3 Press MENU on the remote control. VCR Main Menu appears.
4 Press the ADJUST buttons on the remote control to select First Time Set-Up.
Press ENTER.
5 You will see the First Time Set-Up menu. Press the ADJUST buttons to select
Add/delete channels. Press ENTER.
IMPORTANT
If you are playing back a tape or receiving a video signal from an external
input, Not available will flash on-screen. To correct this, stop the tape or turn
off the menus and switch the VCR’s input to Tuner.
6 You will see the screen for adding or deleting channels. Press the ADJUST
buttons to select the channel that you want to add or delete. Press ENTER to
add the channel; press CANCEL to delete it.
7 When you are finished adding or deleting channels, press MENU three times to
exit the menus.
IMPORTANT
If you use automatic memorization again, you will lose all of the manual
changes you made. All of the channels you deleted will be added; all of the
channels you added will be deleted.
Selecting a Channel
Now that you have memorized channels, and added or deleted some, you will want
to be able to select channels. If you have not yet memorized channels, see page
15, Memorizing Channels Automatically.
Antenna/Cable selections Your VCR can receive
indoor/outdoor antenna VHF/UHF channels 2–69
cable antenna cable channels 1–125
If you try to select a channel number that the VCR cannot receive, the VCR will not
change channels.
selecting channels sequentially
Press CHANNEL on the remote control or turn the jog dial on the VCR front panel.
This will cycle through the channels in sequential numerical order.
selecting antenna, cable or digital cable channels directly
Use the number buttons on the remote control. For example, to choose channel
23, press 2-3.
To select a single digit channel, such as channel 5; press 0-5. You can also press
5, then press ENTER.
Setting Up Your VCR
«Add/delete channels
Channel 39
Not in memory
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER to add
† ∑ ππADJUST to select
≠πππππCANCEL to delete
ƒFirst Time Set-Up
≈Set the clock
∆Memorize channels
«Add/delete channels
∫πMENU to go back
∂ ππADJUST to select
≤¥≥πENTER to enter
∑ ππADJUST to select