Mvc-40g — components (plate compactor) – Multiquip Plate Compactor MVC-40G User Manual
Page 13
MVC-40G PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #4 (06/06/07) — PAGE 13
MVC-40G — COMPONENTS (PLATE COMPACTOR)
Figure 3. MVC-40G Plate Compactor Components
Figure 3 shows the location of the components and general
maintenance parts. The function of each component is described
below:
1.
Hand Lift Handle – When lifting of the compactor by
personnel is required, use this hand lift handle. DO NOT
attach a crane or heavy lifting device to this handle to lift
the compactor.
2.
Lifting Bale – When lifting of the compactor is required
either by forklift, crane etc., tie rope or chain around this
lifting point.
3.
Handle Bar – When operating the compactor use this
handle bar to maneuver the compactor.
4.
Belt Cover – Remove this cover to gain acess to the V-
belts. NEVER run the compactor without the V-belt cover. If
the V-belt cover is not installed, the possibility exist that
your hand may get caught between the V-belt and clutch,
thus causing serious injury and bodily harm.
5.
Vibrating Plate – A flat, open plate made of durable cast
iron construction used in the compacting of soil.
6.
Vibration Case – Encloses the eccentric, gears and
counter weights.
7.
Gasoline Engine – This plate compactor uses a 4-stroke,
air cooled ROBIN EH09-2D gasoline engine. Refer to the
ROBIN owner's manual for engine information.