Multiquip Plate Compactor MVC-40G - Manual (Page 18)

l
PAGE 18 — MVC-40G PLATE COMPACTOR — OPERATION & PARTS MANUAL — REV. #4 (06/06/07)
MVC-40G — INITIAL START-UP
7. If the engine is running properly, slowly return (push inward)
the choke lever (Figure 13) to the “OPEN” position. If the
engine has not started repeat steps 1 through 6.
8. To begin compacting, place the throttle lever (Figure 16) in
the " fast" (run) position.
Stopping The Engine
Normal Shutdown
1. Move the throttle lever to the IDLE position (Figure 17) and
run the engine for three minutes at low speed.
Figure 17. Throttle Lever (Idle)
2. After the engine cools , turn the engine ON/OFF switch to the
“OFF” position (Figure 18).
3. Place the fuel shut-off lever (Figure 19) in the OFF
position.
Figure 18. Engine ON/OFF Switch (OFF)
Figure 19. Fuel Valve Lever (OFF)
Emergency Shutdown
1. Move the throttle lever quickly to the SLOW position, and
place the engine ON/OFF switch in the OFF position.
ALWAYS run engine at full speed while compacting.
CAUTION - Compacting Speed
Figure 16. Throttle Lever (Fast)