Marantz MAR0076 - Manual (Page 22)

1-21
Connect your computer
&
Connect one end of a VGA cable supplied to the video card of the
computer and the other end to the
VGA MONITOR IN connector at the
rear side of the receiver box or at the VGA IN connector 1 at the back
of the monitor in case you have no receiver box connected to the
monitor.
See the instructions with the monitor.
é
Fix the connectors firmly with the screws on the plug.
Connect your Apple Macintosh* computer
Attention: Macintosh computers with separate H and V synchronisation
signals can be used together with a switchable adaptor. Macintosh
computers with Composite Sync and Sync on Green signals may need
another special adaptor or cable. Contact your dealer.
&
Connect a switchable adaptor for Apple video connectors to one end of
a VGA cable.
é
Put the DIP switches on the adaptor in the following positions :
1 2 3 4
off off on on
“
Connect the end of the VGA cable with the adaptor to the video card of
the computer and the other end to the
VGA MONITOR IN connector on
the back of the receiver box or at the VGA IN connector on the back of
the monitor in case you have no receiver box connected.
‘
Screw the connectors down firmly.
To reproduce computer screen information and/or programmes,
see p. 25.
Note:The adaptor shown is not supplied with this set. Please contact your
dealer for more information.
* Apple Macintosh is a registered trademark of Apple Computer, Inc.
Connect your computer
15-pin D sub
(2-row)
15-pin mini D sub
(3-row)
a
MAINS INLET
VGA IN
AUDIO IN
L
R
VGA OUT
2
1 2
AUDIO OUT
English