Connect peripheral equipment, English, Vga menu – Marantz MAR0076 User Manual
Page 24
1-23
Connect peripheral equipment
If the monitor is connected to a video recorder with the EasyLink
function, in some cases the monitor will be switched on, even when it
was in standby. (E.g. playback tape,...)
This is not possible when Child lock On is selected.
Equipment connected with an aerial cable only :
Select the programme number under which you have stored the test
signal with the digit keys.
Equipment connected to a euroconnector, to the
VGA MONITOR IN
connector or to the front side of the receiver box
Press the w key to select
EXT1
,
EXT2, EXT3, FRONT
or
VGA
, according
to where you connected your equipment at the back or the front side
of your receiver.
Remark : Most equipment (decoder, video recorder) carries out the
switching itself.
If you want to change to TV channels?
Enter the programme number of the TV channel which you want to
watch with the digit keys.
To select connected equipment
&
Press the w key in the “keypad” control panel and select
VGA
.
é
Select in the control menu “cursor”
“
Press the red (picture menu), green (sound menu) or yellow (features
menu) key on the door of the remote control to switch on the
VGA
menu
(or press the
MENU
key on the simplified remote control).
‘
Select one of the PC symbols with the cursor up/down:
H
for contrast,
G
for brightness,
for colour temperature,
for horizontal picture position,
for vertical picture position,
(
Press the cursor left/right to alter the selected adjustment.
§
Press one of the coloured keys again (or the
MENU
key on the simplified
remote control) to switch off the
VGA
menu.
VGA menu
MUTE
CHANNEL
VOLUME
TV
Keypad
1
2
3
4
5
6
7
8
9
i+
0
PP
Sub +
Sub -
MUTE
CHANNEL
VOLUME
TV
Go back
Sub +
Sub -
1
2
3
VGA
Front
Scan
1/9
8/9
English