Murphy BCEG-24-20 - Manual (Page 5)

Section 75 00-02-0615
02-29-08 - 1 -
Safety Instructions
This manual contains important safety and operating instructions for Guardian models BCEG-
12-10, BCEG-24-10, and BCEG-24-20.
General Safety Instructions
For safe and correct use of the unit, follow the steps below. Should you have any problems
and the unit does not function as expected, consult the “Troubleshooting Guidelines” section
located at the end of these manual.
• Visually inspect unit for any signs of damage caused by transport or storage. Do
not operate charger if it has been damaged or abused. Return to supplier in this
event.
• Mount charger as outlined in “Charger Location and Connection”, paying
attention to ambient temperature.
• Ensure that AC line voltage is disconnected. Make sure to only connect to the
correct AC supply voltage.
• Ensure unit is properly grounded.
• Check batteries in accordance with manufacturer guidelines.
• Check charger is correct for battery type and voltage.
• Connect unit to batteries, observing correct polarity and ensuring a secure and
tight connection.
• Switch on unit at electrical supply.
• Do not expose charger to rain or snow.
• Use of an attachment not recommended or sold by the battery charger
manufacturer may result in risk of fire, electric shock, or injury to persons.
• Do not disassemble charger. Return to supplier when service or repair is
required. Incorrect reassembly may result in a risk of electric shock or fire.
WARNING – RISK OF EXPLOSIVE GASES
WORKING IN VICINITY OF A LEAD-ACID BATTERY IS DANGEROUS.
BATTERIES GENERATE EXPLOSIVE GASES DURING NORMAL
BATTERY OPERATION.
To reduce the risk of battery explosion, follow these instructions
and those published by battery manufacturers and manufacturer of
any equipment you intend to use in vicinity of the battery. Review
cautionary markings on these products and on any attached
equipment.