IBM EGX-400 - Manual (Page 71)

67 Chapter 4 - Performing Cutting Using a Computer
4-4. Executing Cutting Data Saved on a Memory Card
Saving from Another Program
For a program such as the included 3D Engrave, follow the steps below. You can also use this method with other pro-
grams (as long as the other program uses a driver for Windows).
Saving from Another Program
1 If you are using Windows NT 4.0/2000/XP, log
on to Windows as a member of the "Adminis-
trators" or "Power Users" group.
2 Load a memory card into the memory-card
writer.
3 Open [My Computer]. Note the drive name of
the memory card.
In the example shown in the figure, the drive name is
"E:."
4 For Windows 95/98/Me/NT 4.0/2000:
Click [Start], then [Settings]. Then click [Printers].
For Windows XP:
Click [Start], then click [Control Panel]. Click [Printers
and Other Hardwares], then click [Printers and Faxes].
5 Right-click the icon for the EGX-600 or EGX-
400 driver, then click [Properties].
(Continued on the next page.)