Integra DPS-6.5 - Manual (Page 18)

18
Connecting the DPS-6.5 —Continued
The setup described here is a basic setup that allows you to play discs using just the cables supplied with the player. In
this setup, stereo audio is played through the speakers in your TV.
• This player is equipped with copy protection technol-
ogy. Do not connect this player to your TV via a VCR
using AV cables, as the picture from this player will
not appear properly on your TV. (This player may also
not be compatible with some combination TV/VCRs
for the same reason; refer to the manufacturer for more
information.)
1. Connect the VIDEO OUTPUT and AUDIO OUT-
PUT ANALOG L/R jacks to a set of A/V inputs
on your TV.
Use the supplied AV cable (RCA), connecting the
red and white plugs to the audio outputs and the yel-
low plug to the video output. Make sure you match
up the left and right audio outputs with their corre-
sponding inputs for correct stereo sound.
See the following page if you want to use a compo-
nent or S Video cable for the video connection.
If you need another pair of stereo outputs (and don’t
need to use the multichannel analog outputs), you
can use the FRONT/D.MIX 1 or 2 AUDIO OUTPUT
jacks (page 20).
2. Connect the supplied AC power cord to the AC
INLET, then plug into a power outlet.
Notes:
• Before unplugging the player from the power outlet,
make sure you first switch it into standby using either
the front panel Standby/On button, or the remote con-
troller, and wait of the “GOOD BYE” message to dis-
appear from the player’s display.
• For the above reasons, do not plug this player into a
switched power supply found on some amplifiers and
AV receivers.
• Connect the DPS-6.5 to the TV directly. If you con-
nect the DPS-6.5 to a VCR, TV/VCR combination, or
video selector, the playback picture may be distorted
as DVD videos are copy protected.
Using S Video
If your TV (or other equipment) has an S Video input,
you can use this instead of the standard (composite) out-
put for a better quality picture.
• Use an S Video cable (supplied) to connect the S
VIDEO OUTPUT to an S Video input on your TV (or
monitor or AV receiver).
Basic Setup
R
L
SURR CENTER 1 2 FRONT/D. MIX
AUDIO OUTPUT
DIGITAL
SUB WOOFER OPTICAL
COAXIAL
VIDEO OUTPUT
RS232
VIDEO
S VIDEO
P B Y P R P B Y P R
COMPONENT 2 COMPONENT 1
REMOTE CONTROL
IR
AC INLET
OUT
IN
MODEL NO. DPS- 6.5
RATING:
AC 120 V 60Hz 11 W
SUPER AUDIO CD & DVD AUDIO/
VIDEO PLAYER
L
R
ANALOG
INPUT
VIDEO IN
To power outlet
TV
AV cable
(Supplied)
Power cord
(Supplied)
Connecting Your TV
DPS-6.5.book Page 18 Thursday, August 5, 2004 3:27 PM