IBM Janam XM60 - Manual (Page 49)

XM60 User Manual
10-4 Janam Technologies LLC
The crossed out wheeled bin symbol informs you that the product should not be disposed of
along with municipal waste and invites you to use the appropriate separate take-back systems
for product disposal.
If you need more information on the collection, reuse and recycling of these systems, please contact your
local region’s waste administration. You may also contact your supplier for more information on the
environmental performances of this product.
Battery Warning
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN INCORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS
Use only Janam approved batteries such as the BA-XP-1 and recharge batteries using only Janam approved
chargers. Use only easily accessible wall outlets that are easily reached with the length of the supplied power
cables.
The standard charger provides an easy and convenient way to charge the device. You can purchase the
charger through an authorized dealer. Visit Janam’s website www.janam.com for information.
The socket-outlet shall be installed near the equipment and shall be easily accessible.
GENERAL INFORMATION
1. Before using the standard charger, read all instructions and warnings.
2. Please retain this instruction for future reference.
WARNING
1. No user serviceable parts inside. Do not open the charger. The charger is not serviceable.
2. If found any damage or cracking on the enclosure of the charger, do not use the charger. This charger
shall be disposed of.
3. Do not short-circuit the output terminals of the charger.
4. The charger is for indoor use only. Do not expose the charger to moisture or place the charger at location
which could subject to water spillage.
5. The standard charger is designed for use with this barcode scanner only. Do not use this charger for
other purpose.
OPERATING INSTRUCTION
1. Insert the output plug of the standard charger to the barcode scanner before plug in the charger into ac
power socket outlet.
2. Always unplug the standard charger from the socket outlet after use.
3. Ensure that your local power supply system complies with the technical data of the standard
charger.