Imperial DS1 - Manual (Page 11)

- 10 -
4.1.1 East West Limit
On selecting Limit Setup button, the Limit
Setup menu will pop up. Pressing the E key on
the RCU continuously will take you to the
easternmost point. Press the OK key on the RCU.
The message Would you like to set East limit of
DiSEqC motor? will be displayed for your
confirmation. Place cursor on the OK button on
the screen and press OK key on the RCU to
confirm the East limit.
To set West limit, follow the same steps as East
limit.
4.1.2 Reset DiSEqC limit Place the cursor on
Reset DiSEqC Limit button and then press OK key on the RCU. The message Would you like to
reset limit for DiSEqC positioner? will be displayed for your confirmation. Select OK button by
pressing OK key on the RCU.
Select EXIT to finish antenna setup. The message Are you sure to change the configuration of
Antenna setup? will be displayed. Select OK button on the screen and then wait for the data to
be saved.
4.2 Antenna Setup 2) Fixed
1. Antenna : You can select a maximum of 16
antennas with the combination switches.
2. Type : Select your antenna type to be Fixed
3. Satellite : Select satellite you want.
4. LNB Type : Select your LNB type. If you have
universal LNB, select Univ.
5. LNB Freq. : Enter the proper LNB frequency
referring to your LNB using numeric key on
the RCU.
If you have a dual LNB, enter the proper value
in the value box.
6. Switches (22KHz Tone, DiSEqC) : You can select the switches with
which you want to configure the antenna.
7. C/Ku band control : You can select C/Ku band control by selecting the switch type.Select
EXIT to finish antenna setup. The message Are you sure to change the configuration of
Antenna setup? will be displayed. Please select the OK button on the screen and then wait
for the data to be saved.