Invacare Van Seat PHWH93 - Manual (Page 24)

SECTION 6—FRONT RIGGINGS
Van Seat 24 Part No 1143195
Adjusting the Angle of the Manual Center Mount
Footrest
ƽ WARNING
While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE: For this procedure, refer to FIGURE 6.8 on page 23 and FIGURE 6.9.
1. Engage the release lever with one hand
(not shown) and move the center
mount footrest to the desired angle
with the other hand.
NOTE: Refer to FIGURE 6.8 on page 23 for
the location of the release lever.
2. Disengage the release lever (not
shown) to lock the center mount
footrest in the new position.
FIGURE 6.9 Adjusting the Angle of the
Manual Center Mount Footrest
Adjusting the Footplate Angle
After 2/14/07
NOTE: For this procedure, refer to FIGURE 6.10.
1. Loosen, but DO NOT remove, the two
rear mounting screws and side
mounting screw.
2. Move the footplate to the desired angle.
3. Tighten the two rear mounting screws
and side mounting screw to secure the
footplate in the desired position.
4. Repeat STEPS 1 and 2 for the other
footplate.
FIGURE 6.10 Adjusting the Footplate
Angle - After 2/14/07
Footplate
Center Mount
Footrest
Center Mount
Front Rigging
Footplate
Side Mounting
Screw
Rear Mounting
Screws