JVC GVSP2 - Manual (Page 30)

28
EN
The specified number
is more than the
maximum number of
print pages.
The specified number
is less than the
minimum number of
print pages.
Set ink cassette.
Pull out paper tray and
check paper.
Insert paper tray.
Replace Ink Cassette.
Check ink cassette.
Paper type is not
compatible. Pull out
paper tray and check
paper. (for Windows)
Paper type is not
compatible. Printing
aborted.
(for Macintosh)
Print error has
occurred. Printing
aborted.
Printer is overheated.
Please wait.
Printer is not in usable
condition. Printing
aborted.
ERROR MESSAGES
WHAT TO DO IF ANY OF THE MESSAGES BELOW APPEAR ON THE PC
ⅷ Appears when:
Ⅵ Action:
Message Page
Ⅵ Set a value that does not exceed the maximum number of
sheets that can be printed.
Ⅵ Enter a value other than “0.”
ⅷ This message appears if no ink cassette has been installed,
or if it has not been installed properly.
Ⅵ Insert an ink cassette and close the door.
ⅷ This message appears if the printer is out of paper.
Ⅵ Load more paper.
ⅷ This message appears if the paper tray has not been
inserted.
Ⅵ Insert the paper tray.
ⅷ This message appears if the ink cassette has been used up.
Ⅵ Replace the old cassette with a new one.
ⅷ This message appears when the paper size set on the PC
does not match the type of ink cassette being used.
Ⅵ Check that the paper size set on the PC matches the ink
cassette.
ⅷ This message appears when a damaged ink cassette is
inserted.
Ⅵ Replace with a new ink cassette.
ⅷ This message appears if the paper size set on the PC does
not match the printing paper.
Ⅵ Check that the paper size set on the PC matches the
printing paper.
ⅷ This message appears if the paper size set on the PC does
not match the printing paper.
Ⅵ Check that the paper size set on the PC matches the
printing paper.
ⅷ This message appears if the printing operation could not
be performed normally. This message is displayed when
there is a paper jam, when paper orientation is incorrect,
or when the paper is upside down.
Ⅵ Remove the paper that was ejected.
Ⅵ Turn the power off, unplug the power cord, plug the
power cord back in, and then turn the power on again. If
after doing so this message still appears, contact your
dealer or a JVC Service Center.
ⅷ This message appears while the printer is cooling off if the
printer’s internal temperature has risen too high.
ⅷ This message appears if the printer is being used by
another device.
Ⅵ Print to the GV-SP2 after the other device has finished
printing.
18, 27
18, 27
8
9
9
8, 18, 26
8
9, 18
9, 26
—
—
17, 25