JVC UX-A10DVD - Manual (Page 15)

12
English
To connect audio equipment with an optical digital
output terminal
By using an optical digital cord (not supplied), you can
connect audio equipment with an optical digital output
terminal.
AUDIO
PCM
AUX
RIGHT LEFT
PCM/
STREAM
OPTICAL
DIGITAL
IN
DVD OPTICAL
DIGITAL
OUT
Protective plug
To the optical
digital output
Before connecting the
other equipment,
remove the protective
plug from the terminal.
Audio equipment with
an optical digital output
Optical digital
cord
To listen to or to record the sound from audio equipment
connected to the OPTICAL DIGITAL IN terminal, select
“AUX-DIGITAL” as the source to play. (See page 20.)
• You can only play the sources recorded with Linear PCM
through the OPTICAL DIGITAL IN terminal.
When connecting audio equipment to the OPTICAL
DIGITAL IN terminal
The above connection allows you to perform digital-to-digital
recording on an MD. (See page 61.)
AUDIO
PCM
AUX
RIGHT LEFT
PCM/
STREAM
OPTICAL
DIGITAL
IN
DVD OPTICAL
DIGITAL
OUT
Right
Analog audio equipment
To audio output
Left
Right
Left
RCA pin plug
cord
To connect analog audio equipment
By using an RCA pin plug cord (not supplied), you can
connect analog audio equipment.
• Be sure that the plugs of the audio cords and the jacks on
the rear of the unit are color-coded:
White plugs and jacks are for left audio signals, and red
ones for right audio signals.
To listen to or to record the sound from analog audio
equipment connected to the AUX jacks, select “AUX” as
the source to play. (See page 20.)
DO NOT play the sources recorded with other than
Linear PCM, such as Dolby Digital or DTS, through
the OPTICAL DIGITAL IN terminal. Playing such
sources may cause noises from the speakers and may
damage them.
EN08_17UX-A10DVD[UB].pm6 02.10.7, 8:08 AM 12