JVC UX-A10DVD - Manual (Page 51)

48
English
To stop during play, press
7.
To fast-wind to the left, press 4.
To fast-wind to the right, press
¢.
To remove the cassette, push
) (PUSH OPEN).
DO NOT push ) (PUSH OPEN) during tape play.
To play both sides—Reverse mode
You can set the deck to play just one side or both sides of a
tape once, or both sides continuously.
Press REV. MODE.
• Each time you press the button, the reverse mode
changes as follows:
: Plays back only one side (front or reverse).
: Plays back the front and reverse sides once.
: Plays back both front and reverse sides
continuously.
• The use of the C-120 or thinner tape is not
recommended, since characteristic deterioration
may occur and this tape easily jams in the pinch
rollers and the capstans.
• You can also play back type II and type IV tapes;
however, the sound quality (tone) may not be
reproduced properly.
Playing Back a Tape
You can play back type I tapes.
1
Push
) (PUSH OPEN).
The cassette holder opens.
2
Put a cassette in with the exposed part of the tape
down.
3
Push ) (PUSH OPEN) gently to close the cassette
holder.
4
Press TAPE 2 3.
Playback starts (if the unit is in standby, the unit
automatically turns on).
To change the tape direction, press TAPE
2 3.
• Each time you press the button, the tape direction
changes as follows:
: Plays the front side (left to right).
: Plays the reverse side (right to left).
When the tape plays to the end, the deck automatically
stops if the reverse mode is set to
or . (See
“To play both sides—Reverse mode” in the right
column.)
Cassette holder
Cassette holder
) (PUSH OPEN)
Reverse mode
and tape direction
indicators
Tape direction (left to right)
TAPE indicator
EN47_48UX-A10DVD[UB].pm6 02.10.7, 8:10 AM 48