Sprint Nextel SCP-7050 - Manual (Page 168)

152 Section 2I: Using Sprint Ready Link
Receiving a Sprint Ready Link Call
To receive a Sprint Ready Link call:
1. Make sure your phone’s Sprint Ready Link mode is
enabled. (See “Setting Sprint Ready Link Mode” on page
144.)
2. When you receive a Sprint Ready Link call from a contact,
“R-Link Call,” the contact’s name, and the
Sprint Ready Link number are displayed. (You do not
need to take any action to answer the call.)
Ⅲ
When you receive a group call, “Group Call,” the
group member’s name, and the Sprint Ready Link
number are displayed.
3. If the person placing the call has kept the floor (held the
Ready Link/Memo key), you will see the contact’s name
and Sprint Ready Link number along with “has floor,”
and you will hear the caller speaking.
4. When the caller finishes speaking and releases ,
you will see “Floor is open” on the display screen. Press
and hold
to take the floor and reply to the caller.
(You will see “You have floor” and hear a tone confirming
that you may speak.)
5. When the conversation is finished, press .
Note: You can change the volume and the speaker setting while a
Sprint Ready Link call is activated.
Volume: Adjust the voice
volume by using the Side Volume key or by pressing the
navigation key up or down (except when you are pressing and
holding the Ready Link/Memo key).
Speaker: Switch the
speaker on or off by pressing the Speaker key.
Tip: You can also receive a Sprint Ready Link call with the phone
closed. Press and hold the Ready Link/Memo key to take the
floor when the floor is open.