KVH Industries TracVision G8 - Manual (Page 103)

5.11 Replacing the Azimuth Motor
1. Disconnect the motor cable from the azimuth motor.
Figure 5-15 Azimuth Motor Cable
2. Remove the motor shield by pressing on the two sides of
the shield above the release tabs.
3. Remove the four #8-32 screws and locking nuts securing
the motor to the antenna frame. Remove the old azimuth
motor.
Figure 5-16 Azimuth Motor (Shield Removed)
Maintenance
54-0198 107
#8-32 Screws
(x 4)
Azimuth Motor
Motor Cable
Connector
Azimuth Motor
Release Tab