KVH Industries TracVision G8 - Manual (Page 109)

5.15 Replacing the Skew Motor
(Linear Quad LNB Systems Only)
1. Using a 7 ⁄
16
" wrench, carefully disconnect the four RF
cables from the LNB.
Figure 5-25 Linear Quad LNB/Feed Tube Assembly
2. Disconnect the elevation and azimuth gyro cables from
the in-line connectors.
3. Disconnect the skew motor cable from the PCB module.
Figure 5-26 Skew Motor Cable Connector on PCB Module
Maintenance
54-0198 113
RF Cable
Connectors
LNB
Skew
Motor
#8-32 Screws (x 4)
POWER
ELEVATION GYRO INTERNAL SENSOR SKEW MOTOR
ELEVATION & AZIMUTH MOTORS AZIMUTH/ROLL GYRO LIMIT SWITCHES
FUSE
Skew Motor
Cable Connector
Gyro Cable
Connectors