Kompernass KH 1410 - Manual (Page 9)

- 7 -
Exhaust filter
Attention!
Before taking the filter out, remove the plug 9 from
the power socket.
1. Press the locking device ẫ of the exhaust filter
cover 3 in the middle and at the same time
pull the exhaust filter cover 3 away from the
vacuum cleaner to open it.
2. Remove the grill ẩ as well as the exhaust
filter Ẩ .
3. Remove the dust particles from the exhaust
filter
Ẩ .
Notice:
Should the exhaust filter Ẩ be heavily soiled, rinse
it thoroughly under clean running water. Afterwards
allow it to dry out ( ca. 15 hours at room temperatu-
re). Replace it only when it is completely dry.
4. Replace the exhaust filter Ẩ and the grill ẩ .
5. Slide both of the lugs Ẫ of the exhaust filter
cover 3 into the recesses on the vacuum
cleaner.
6. Press the exhaust filter cover 3 to until it audi-
bly engages.
Cleaning and care
Attention!
Before cleaning the appliance, remove the plug 9
from the power socket. Risk of electric shock!
Clean the housing with a lightly moistened cloth. Do
not use abrasive or aggressive cleaning materials.
These could damage the upper surfaces.
Take note of the chapter „Filters“ for the cleaning of
the filters.
Disposal
Do not dispose of the appliance in
your normal domestic waste. This
product is subject to the European
guideline 2002/96/EC.
Dispose of the appliance through an approved
disposal centre or at your community waste facility.
Observe the currently applicable regulations.
In case of doubt, please contact your waste disposal
centre.
Dispose of all packaging materials in an
environmentally friendly manner.
IB_KH1410_E2687_GB_LB4+5 21.01.2008 10:23 Uhr Seite 7