Liebherr WF1051 - Manual (Page 22)

A delight in freshness
WF1051 / EWTNes 2956 20
S
IDE
-B
Y
-S
IDE
I
NSTALLATION
Figure 25: To install the WF1051 and RB1400
appliances side-by-side, proceed as follows:
- Always place the WF1051 and RB1400 with
the hinges on the left-hand side (looking from
the front).
Installation with SBS Ventilation Grille Set:
1. Affix the spacer (1) on the side wall of the
appliance – remove the protective film.
2. Push the appliances together,
- align them parallel to each other.
3. Use a level on the top to align them to the same
height:
4. Use the open-end wrench 10 mm (3) to adjust
the feet at the front of the roller base. Turn
clockwise for up and counterclockwise for down.
For the rear, turn the adjusting bolt (2) clockwise
down and counterclockwise up.
4.
Figure 25
Unpacking
Unpack the side by side installation kit and check
with the provided parts list if all parts are included.
The part numbers given in the parts list are identical
to the numbers in the respective fi gures.
For installation you will need the following tools:
Included:
- Star Key Torx® 15
- Star Key Torx® 20
- Star Key Torx® 25
- Socket Wrench 8 mm
- Open-end Wrench 10 mm
Not in package:
- Phillips (star) screwdriver
- Level
- Ruler