Lok8u K8SLI - Manual (Page 43)

K8SLI
37
Note: If you select Min. or Max. Power Saving modes, the “HDD Power Down” value will fixed.
User Define、Min Saving、Max Saving
Video Off Method
This option determines the manner in which the monitor goes blank.
Options:
V/H SYNC+Blank This selection will cause the system to turn off the vertical and horizontal
synchronization ports and write blanks to the video buffer.
Blank Screen This option only writes blanks to the video buffer.
DPMS Support (default) Initial display power management signaling.
HDD Power Down
When enabled, the hard disk drive will power down after a certain configurable period of system
inactivity. All other devices remain active.
Options: Disabled (default)、1 Min、2 Min、3 Min、4 Min、5 Min、6 Min、7 Min、8 Min、9 Min、
10 Min、11 Min、12 Min、13 Min、14 Min、15Min
HDD Down In Suspend
This allows you to enable/ disable the hard driver power down in the suspend state.
Options: Disabled (default)、Enabled
Soft-Off by PWRBTN
In situations where the system enters a “hung” state, you can configure the BIOS so that you are
required to press the power button for more than 4 seconds before the system enters the Soft-Off
state.
Options: Delay 4 Sec, Instant-Off (default).
PCI PME Wake Up
This option will also cause the system to wake up with any onboard LAN activity.
Options: Disabled (default)、Enabled
Ring Wake Up
This option allows you to awaken the system upon receiving an incoming call to modem device.
Options: Disabled (default)、Enabled.
USB Wake up
This item allows you to awaken the system from suspend mode using a USB devices.
Options: Enabled、Disabled (default)