Lyngdorf Audio TDA 2200 User Manual
Page 30
30
The saved calibration volume from the guided set-up is used as a default when adding
extra focus/listening and room positions though, as mentioned, the volume can be
changed at any time between measurements to suit a particular situation.
After a successful measurement the following message is displayed. The value of
Roomknowledge can be different.
Press enter to continue.
Choose
Yes to save the measurement or choose No to exit without saving the current
measurement.
Choose between focus/listening position presets 2 - 8 and press enter. If you wish to
overwrite an existing focus filter (2 to 8 can be overwritten) or you are trying to save a new
filter on an existing preset then the following will be displayed.
When the preset number has been chosen, the volume turns down to default or lower and
the new focus filter is calculated and saved.