Liebherr HCS 20 - Manual (Page 12)

12
Mounting the refrigerator door panels
- Figures 21 - 28
3. Loosen the three cross-head screws of the
bracket and move the panel to the left until it
makes contact with the center rail Figure 22.
4. Tighten the three cross-head screws Figure 22.
Figure 21
Figure 22
I
NSTALLATION
5. Close the door and check the height of the
panel.
6. Align the panel in its vertical position if
necessary. Loosen the hex nuts and turn the
adusting bolts using a screwdriver for slotted
screws. Figure 23.
7. Check the vertical position of the panel again
and tighten the hex nuts finally.
Figure 23
Figure 24
To make it possible to fasten the refrigerator
panel at the bottom the soft-stop cylinder must be
dismantled.
8. Stick a small screwdriver under the retaining
clamp and lever out. Figure 24.
1. Open the left refrigerator door and suspend the
panel on the adjusting bolts Figure 21.
2. Screw on the hex nuts to the adjusting bolts and
tighten temporarily Figure 21.