Liebherr HCS 20 - Manual (Page 9)

Figure 11
Figure 13
Figure 12
Anti - tipping bracket
Compressor mounting
plate
Wall
Appliance
9
Connection to the Water Supply
1. Install the shut-off valve, water filter and auto-
matic shut-off device as required.
2. The solenoid valve has a Metric R3/4 male con-
nector. A R3/4 (metric) to a 1/4" OD adapter is
supplied with the icemaker.
3. Move the appliance towards the final position
and leave a gap of approx. 30" behind.
4. Insert the water supply line into its intended
opening at the back of the appliance (Figure
11).
5. Move the power supply line to the area of the
electrical outlet.
Do not connect to the electrical outlet
before the installation is completed
and the water line is connected to the
solenoid valve.
6. Push the appliance slowly to the back wall until
the compressor mounting plate makes contact
with the anti-tipping bracket (Figure 12).
To prevent the appliance from tipping
forward the compressor mounting plate
must have contact with the anti tipping
bracket (Figure 12).
7. The water line is visible at the front of the appli-
ance. Screw the OD adapter onto the solenoid
valve and connect the water line with the adapt-
er (Figure 13).
8. Open the shut-off valve for the water supply and
check the entire water system for leaks.
I
CE
M
AKER