Light & Motion VX2000 - Manual (Page 12)

23 22
Light Operation
Before you turn on the Pro lights, verify that the mode selector (flat
position of black ring around red power button) is set to the P setting.
Before you turn on the Elite lights, verify that the mode selector (flat
position of black ring around red power button) is set to the E setting.
Operation with SunRay-X Pro Lighting System
Pro lights can be operated either by the Pod Power Button or from the Smart
Grip controls.
Operation from Smart Grips
1)
Activate initial power up by pressing the Pod Power Button. (Refer Fig 28).
After initial power up lights may be controlled using LIGHT button on the
Smart Grip controls.
2) Turn off lights by pressing the LIGHT button.
Operation from Battery Pods
1)
Turn on light by pressing the Power Button on the rear cap (Refer Fig 28).
2) Turn off light by pressing the Power Button on the rear cap.
Operation with SunRay-X Elite Lighting System
Elite lights can be operated either by the Pod Power Button or from the Smart
Grip controls.
Operation from Smart Grips
1) Activate initial power up by pressing the Pod Power Button. (Refer Fig 28).
2) Use the LIGHTS button to cycle through power settings.
3) Turn off lights by pressing and holding the LIGHT button for three seconds.
Operation from Battery Pods
1) Turn on light by pressing the Power Button on the rear cap (Refer Fig 28).
2) Press the red button again to change the light output level.
3) Turn off light by holding the red button down for three seconds.
Post Dive Cleaning
1) After each dive, you should dunk the lights and pods in fresh water.
2) Press the red button to flush out any water.
3) After you are geared down and completely dried off, simply towel dry the
lights in a safe dry place.
Do not leave your lights in the rinse bucket with other
equipment. Underwater gear has been known to be
damaged by jostling against other products.
Storage
After diving remove your batteries and charge them. Leaving your batteries
discharged will significantly reduce the life of the battery. Store as you would
any other valuable piece of electronic equipment.
Other Maintenance
• Apply a light film of o-ring grease to cables and connectors to prevent pre-
mature degradation.
• We highly recommend a factory annual service to maintain proper operation
of your SunRay Lights.
• If a battery pod is flooded, immediately remove the battery, and rinse the
pod with fresh water. Most non-electrical parts will be salvageable if not
corroded by salt water.
(Fig. 28)
Power Button
LED Window