Lucent Technologies MDW 9031 - Manual (Page 6)

Quick Reference
MDW 9031/9031DCP Wireless Pocket Phone Quick Reference
503-801-165 2 Issue 2 February 1999
Handset Display
1 Information you would see on a wired system phone’s display, (except
time), based on your communications system:
LCL:P, D, M1, or M2 = Local Mode:
communications system
WIRELESS TEST = Handset in Wireless Test Mode
VIBR = Vibrator enabled
PSEL = Line Preselection enabled
PRESELECTION:ON/OFF = Line Preselection Mode:status
CHANGE BUTTN MAP = Communications system setting is
wrong
MAP:P, D, M1, M2 = Button Mapping Mode: setting
NO LINK = Handset is not communicating with radio module
2 MSG indicates that you have a message.
3 RANGE indicates that the handset is out of range or almost out of range.
Handset also beeps.
4 ON indicates that handset was turned on by pressing
O.
5 Battery icon flashes to indicate a low battery condition. Handset also
emits 2 beeps.
6 No Ring icon indicates that the alerter is disabled.
7 MUTE indicates that handset microphone was turned off by pressing
M.
1
2
8
7
6
9
5 4 3