Lowrance electronic GlobalMap 7000C - Manual (Page 74)

68
Menus for changing Com Port settings.
For assistance in configuring the unit to communicate with another
device, consult the factory; customer service phone numbers are in the
back of this manual. Also see the entries below for
Configure DGPS and
Configure NMEA. To set Com Port Configuration:
1. Press MENU | MENU |
↓ to
S
YSTEM
S
ETUP
| ENT .
2. Press
↓ to
C
OMMUNICATIONS
P
ORT
| ENT .
Configure DGPS
This unit will recognize Starlink

, Magnavox

and Lowrance DGPS
receivers.
1. Press MENU | MENU |
↓ to
S
YSTEM
S
ETUP
| ENT .
2. Press
↓ to
C
OMMUNICATIONS
P
ORT
| ENT .
A. If you have a Magnavox receiver, press
↓ to
M
AGNAVOX
| ENT .
B. If you have a Lowrance or Starlink receiver, press
↓ to
S
TARLINK
| ENT .
C. If you have a Magnavox or Starlink, press EXIT | EXIT | EXIT . This is
the only setup necessary. If you have a Lowrance receiver or another
Magnavox- or Starlink- compatible brand, continue with these steps:
3. Press
↓ to
C
ONFIGURE
NMEA |
→ to
C
ONFIGURE
DGPS | ENT .
4. Press ENT , then use
↑ ↓ → ← to enter the station frequency, then
press ENT .
5. Press
→ to
B IT R ATE
| ENT then use
↑ ↓ to select the station bit rate,
then press ENT .
6. A. If you are not using a Starlink DGPS receiver, press
EXIT | EXIT | EXIT | EXIT to return to the previous page.
B. If you are using a Starlink DGPS receiver, press
↓ to
S
TARLINK
A
UTO
T
UNING
M
ODE
|press ENT |press EXIT | EXIT | EXIT | EXIT to return to the pre-
vious page.
Configure NMEA
You can configure the unit to use specific NMEA sentences.