LifeSource Easy OnE stEp Blood Pressure Monitor UA-631V - Manual (Page 14)

LifeSource Health Line (Toll-Free): 1-888-726-9966 E-10
This monitor automatically stores up to sixty (60) blood pressure and
pulse measurements in memory. Measurements stored in memory are
assigned an index number in the order of the newest to the oldest.
The oldest reading displays as “n01”. The M symbol in the upper left
corner of the display screen indicates that you are viewing a previous
measurement stored in memory.
To retrieve readings, follow these simple steps:
1 .
When the display screen is blank, press and quickly
release the Memory button. You will see the index
number of the most recent blood pressure that was
taken followed by the measurement.
2 .
If you want to retrieve other measurements in
memory, press and release the Memory button
repeatedly until the desired index number is
reached (e.g. n04). The measurement will then be
displayed.
3 . The display will shut off automatically a few
seconds after the readings are displayed.
If there are no measurements stored in memory, you
will see two 0s displayed vertically followed by a
blinking “A00”.
To clear the measurement history from memory, press and hold the
Memory button for at least five seconds while the display screen
is showing blank. Release the Memory button when you see the M
symbol in upper left hand corner of the display flash and disappears.
This indicates that the memory has been cleared.
NOTE: Stored measurements, will be lost if batteries become low or are removed.
ABOUT MEMORY