Polycom SpectraLink 1725-36038-001 - Manual (Page 32)

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
32 PN: 1725-36038-001_B.doc
SVP Server IP The IP address of the SpectraLink 8000 SVP Server. If
using Static IP configuration, this is simply the IP address of the
SpectraLink 8000 SVP Server. Note that the SpectraLink 8000 SVP
Server must be statically configured to have a permanent IP
address. If DHCP is being used, the handset will try the following,
in order: the DHCP option 151, then a DNS lookup of
“SLNKSVP2” if the DHCP options 6 (DNS server) and 15 (Domain
Name) are configured.
SIP TFTP Server IP The IP address of a TFTP server on your network,
which holds SIP configuration files. In static mode, this parameter
must be configured with an IP address. In DHCP mode, the SIP
TFTP server may be specified by defining the address on the DNS
server for the name “siptftp” If this is not defined, the address
specified in option 66 will be used. See Chapter 4, SIP Integration
Factors.
OAI Server IP The IP address of the SpectraLink 8000 OAI
Gateway. If using Static IP configuration, this is simply the IP
address of the SpectraLink 8000 OAI Gateway. If DHCP is being
used, the handset will try the DHCP option 152.
SSID
Enter the SSID.
Security
*NONE disables any 802.11 encryption or security authentication
mechanisms.
For WEP, WPA-PSK, and WPA2-PSK set each of the following
options to match exactly the settings in the APs.
Encryption codes display as they are entered. For security reasons
codes will not display when a user returns to the Admin menu,
Encryption options.
WEP (Wired Equivalent Privacy) is a wireless encryption protocol that
encrypts data frames on the wireless medium allowing for greater
security in the wireless network. If WEP is required at this site, you
must configure each handset to correspond with the encryption
protocol set up in the APs. Select the entries from the options below to
enable the handset to acquire the system.