Polycom SpectraLink 1725-36038-001 - Manual (Page 90)

SpectraLink 8020/8030 Wireless Telephone: Administration Guide for SIP
90 PN: 1725-36038-001_B.doc
Message Description Action
Bad Config Some needed configuration parameter
has not been set. Check all required handset
configuration parameters for valid
settings.
Bad ESSID The handset is configured for “static
ESSID” (as opposed to “Learn once” or
“Learn always”), and no ESS ID has
been entered. Enter an ESSID in the configuration
settings or change to one of the “Learn”
modes.
Bad Phintl File Handset software download files are
incorrect or corrupted. Download new software from the
Polycom website per Software
Maintenance .
Bad Program File Handset software download files are
incorrect or corrupted. Download new software from the
Polycom website per Software
Maintenance .
Bad SIP TFTP IP A bad unicast address has been
entered for the SIP TFTP server in
static entry mode. Re-enter the correct IP address in the
administrative menus for static IP
addresses.
(battery icon),
Battery Low,
beep (audio) Low battery. In call: the battery icon displays and a
soft beep will be heard when the user is
on the handset and the battery charge
is low. User has 15–30 minutes of
battery life left.
Not in call: The battery icon displays
whenever the battery charge is low The
message Battery Low and a beep
indicate a critically low battery charge
when user is not on the handset. The
handset will not work until the Battery
Pack is charged.
Battery Failure The Battery Pack is not functioning. Replace the Battery Pack with a new or
confirmed SpectraLink Battery Pack.
Only SpectraLink Battery Packs will
work.
Battery Failed Battery Pack is damaged or
incompatible with handset. Replace the Battery Pack with a new or
confirmed SpectraLink Battery Pack.
Only SpectraLink Battery Packs will
work.
Can’t Renew
DHCP
yyy.yyy.yyy.yyy y…y = DHCP server IP address.
DHCP server is not responding to
initial renewal attempt. Configuration problem. Check the IP
address configuration in the DHCP
server.
Charging … The handset is charging in the desktop
charger. No action needed.
Charge Complete The handset is now fully charged. No action needed.
Checking Code Handset is contacting the TFTP server
to determine if it has a newer version
of software that should be
downloaded. None, this message should only last for
approximately one second. If message
remains displayed, power off and
contact customer support for a
replacement phone.