Connecting the mgc-50 to the ip network, Connecting the mgc-50 to the ip network -31 – Polycom DOC2237A User Manual
Page 51
Advertising
MGC Hardware and Installation Manual
2-31
Connecting the MGC-50 to the IP Network
If an IP network Interface card is installed in the MGC, connect the 8-pin
RJ-45 connector of the LAN network cable to the LAN-323 RJ-45 jack on the
rear panel of the MGC.
Figure 2-17: LAN IP network connection
The IP network properties must be defined in the IP Network Service. For
details, see MGC Administrator’s Guide, Chapter 3.
Advertising