Figure 49 diag: barcode screen, Figure 49, The rig – Quantum ATL M-Series User Manual
Page 106
Chapter 5 Running Diagnostic Programs
Running the Barcode Scanner Test
88
ATL M-Series User’s Guide
Figure 49 Diag:
Barcode Screen
6
Press the
Up
and
Down
buttons to change the highlighted
number.
7
Press
Left
to move the highlight to the next number.
8
Repeat steps
and
as necessary until the desired cycle count
number is displayed.
9
Press
Right
until the cursor is all the way to the right and the
Select
button appears.
10
Press
Select
to set the cycle count, or press
Cancel
to return to
the
Diags: General
screen without running the
Barcode Scanner
test.
The test starts and the GUI displays a
Running Diag
screen. The
test stops automatically after completing the selected number
of cycles. When the test is complete, the GUI displays a screen
indicating the test status.
To abort the test before it completes the selected number of
cycles, press
Stop
.
11
Press
Back
to return to the
Diags: General
screen.
Note:
Setting the cycle count to
0000
causes the test to run
continuously.