Quantum ATL M-Series - Manual (Page 73)

Chapter 3 Changing the Library Configuration
Setting the Library ID
ATL M-Series User’s Guide 55
Setting the Library ID
3
By default the library SCSI ID is set to 0. To change the library SCSI
ID setting:
1 Access the Configuration screen (see Accessing the
Configuration Screen ).
2 Press the Up or Down buttons until Library ID is highlighted.
3 Press Select .
4 Use the Up or Down buttons to select the desired SCSI ID.
Available settings are 0 through 15 .
5 Press Select .
To return to the Configuration screen without changing the
option setting, press Cancel .
6 Press Main to return to the main screen.
Caution: If you do not return to the main screen after
changing this setting, your change will not be
saved to NVRAM.
Note: You must reboot the library before this setting will
take effect.