QSC Audio ISA 500T - Manual (Page 25)

CONNECTIONS:
SECURING OUTPUT WIRING TO CHASSIS
Part of any quality sound system installation is ensuring that your connections remain tight and reliable over time. Making high quality
terminations to the screw terminals is one part of that reliability equation. Keeping those terminations from moving is the other part. If
the connections are prevented from stress and strain, they should remain reliable.
All ISA amplifiers have integral wiring tie-down points stamped into the steel chassis. When used properly, they will help keep your
connections reliable. Securing the wires to the tie-down tabs will keep the stress of wire movement and “inadvertent” pulling off the
connections. These tie-down points are located on the rear panel, right side, above the IEC power connector.
After all connections have been made and verified, carefully “dress” the wires into neat lines straight form the connection and across
the tie-down tab. Working from one end to the other, secure each lead (or group of leads) to its respective tie-down tab. Continue until
all wires have been secured.
25