QSC Audio ISA 500T User Manual
Page 37
SPECIFICATIONS
ISA 300T
ISA 500T
ISA 800T
OUTPUT POWER
in watts
Low Impedance FTC:
8 ohms per channel (20-20k Hz., 0.1% THD)
185
260
450
4 ohms per channel (20-20k Hz., 0.1% THD)
280
425
650
Low Impedance EIA:
16 ohms (1 kHz., 0.1% THD, 1 channel driven)
100
140
250
8 ohms (1 kHz, 0.1% THD, 1 channel driven)
200
280
475
4 ohms (1 kHz, 0.1% THD, 1 channel driven)
300
500
750
2 ohms (1 kHz, 1% THD, both channels driven)
430
700
1200
Low Impedance Bridged Mono:
16 ohms, 20–20k Hz, 0.1% THD
370
520
900
8 ohms (1 kHz, 0.1% THD)
600
900
1500
4 ohms (1 kHz, 1% THD)
830
1400
2400
Distributed High Impedance:
70 volt (50 Hz - 16 kHz, 0.5% THD, per channel)
300
500
800
100 volt
300
500
800
140 volt (bridge)
600
1000
1600
200 volt (bridge)
600
1000
1600
DYNAMIC HEADROOM (all models)
2 dB at 4 ohms
DISTORTION (SMPTE-IM, all models) LESS THAN 0.01% LESS THAN 0.01% LESS THAN 0.01%
FREQUENCY RESPONSE (all “T” models)
DIRECT OUTPUTS- -3 dB at 50 Hz to -0.5 dB at 20 kHz
(at 10 dB below rated output power)
DISTRIBUTED OUTPUTS- 50 Hz to 16 kHz, +0 dB, -3 dB
DAMPING FACTOR (all models)
Greater than >200 for 8 ohm load
SIGNAL to NOISE (unweighted, 20-20k Hz.)
-100 dB -100 dB -100 dB
VOLTAGE GAIN (gain control set to 0 dB)
30.5 dB (33.4.X)
33.0 dB (44.7 X)
35.0 dB (56.2 X)
INPUT SENSITIVITY for rated power into 8 ohms
+3.43 dBu (1.15 Vrms)
+2.81 dBu (1.07 Vrms) +2.81 dBu (1.07 Vrms)
INPUT CLIPPING, Vrms (all models)
+22 dBu
INPUT IMPEDANCE (all models)
10k ohms unbalanced , 20k ohms balanced
37