TERK Technologies XMDPIO110 - Manual (Page 5)

8
Switching the display
XM channels each have a channel number and channel name. XM
programming also carries song or program title, artist name and
category, when available.
• To change the XM information shown on your display press
DISPLAY repeatedly to switch between the following settings:
Channel name—Artist name/feature—Song/program title—
Channel number—Channel category
Note: When you switch the display, the text is automatically scrolled.
Scrolling the text in the display
You can scroll the text to the left so that the rest of the text can be seen.
• Press DISPLAY and hold until the text begins to scroll to the left.
The rest of the text will appear in the display.
Switching the channel select mode
You can switch from category or channel mode by following the
steps listed below. Initially, channel number select mode is selected.
1 Press FUNCTION to select MODE. Press FUNCTION until MODE
appears in the display.
2 Press or to select the desired channel select mode.
Press or repeatedly to switch between the following
settings:
CH NUMBER (Channel number select mode)—CATEGORY (Channel
category select mode)
Note: Depending on the head unit you are using, it may be possible
to directly switch between the channel select modes using the
allocated button. For details, refer to the head unit’s manual.
Smart Digit
al Adapt
er
7
XM Satellite Radio Operation
(continued)
Note: If you press and hold or , you can
increase or decrease channel number continuously. You can also
select a channel from a desired channel category. (Refer to
“Switching the channel select mode”, on page 8.)
• Press SOURCE and hold until the unit turns off.
Important: It may take a few seconds before you can hear anything
while this unit acquires and processes the satellite signal when you
turn power on, change the source to XM tuner, or select a channel.
Note: Display changes as follows when you switch channels or
operate in other ways. The text of selected display* is automatically
scrolled. Channel number—Channel name—Selected display *
* For details, refer to “Switching the display” on page 8.
Storing and recalling channels
If you press any of the preset tuning buttons 1–6 you can easily store
up to six channels for later recall with the touch of a button.
• Memory and recall are for broadcasts. If you recall a memorized
broadcast that has been moved to another channel, the channel to
which the broadcast was moved is selected.
When you find a channel that you want to store in memory press a
preset tuning button 1–6 and hold until the preset number stops
flashing.
The number you have pressed will flash in the preset number
indicator and then remain lit. The selected channel has been stored
in memory.
The next time you press the same preset tuning button 1–6 the
channel is recalled from memory.
Notes:
• Up to 18 channels, 6 for each of the three XM bands can be stored
in memory.
• When channel number select mode is selected, you can also use
and to recall channels assigned to preset tuning buttons 1–6.
• If a channel you have recalled cannot be selected, a message is
displayed for 2 seconds and the unit returns to the operating
status before the channel was recalled.
Smart Digit
al Adapt
er