T-Fal Emerilware - Manual (Page 3)

When using electrical appliances,
basic safety precautions should always
be followed to reduce the risk of fire,
electric shock, and/or injury to persons,
including the following:
1. Read all instructions carefully
before using the appliance.
2. To protect against risk of electrical
shock, do not immerse cord, plug
or appliance in water or other
liquids.
3. Close supervision is necessary
when any appliance is used near
children.
4. This appliance is not intended for
use by children.
5. Unplug from outlet when not in
use, before putting on or taking off
parts, and before cleaning.
6. Avoid contact with moving parts.
7. Do not operate any appliance with
a damaged cord or plug. If the
appliance malfunctions or has
been damaged in any manner,
return it to the nearest authorized
T-fal service facility for
examination, repair or adjustment.
8. The use of accessory attachments
not recommended by T-fal may
cause injuries.
9. Do not use outdoors.
10. Do not let cord hang over edge of
table or counter.
11. Keep hands and utensils out of
blender jar while blending to
reduce the risk of severe injury to
persons or damage to the blender.
A scraper may be used but must be
used only when the blender is not
running.
12. Blades are sharp. Handle carefully.
13. To reduce the risk of injury, never
place cutter assembly blades on
base without jar properly attached.
14. Always operate blender with cover
in place.
15. When blending hot liquids, remove
measuring cup (center piece of
cover) to allow steam to escape.
16. Make certain the voltage of the
appliance is in accordance with
your domestic supply.
17. Never use the appliance on a hot
surface or near fire.
18. Do not place ingredients bigger
than one inch into the appliance.
They could stop the blade and
overheat the appliance.
19. Do not use the appliance for other
than intended use.
20. Do not place the blender jar in a
microwave oven.
21. Keep fingers away from all moving
parts.
22. Never feed food by hand. Always
use food pusher.
23. Keep hands and utensils away
from moving blades or discs while
processing food to reduce the risk
of severe injury to persons or
damage to the food processor. A
scraper may be used but must be
used only when the food processor
is not running.
24. To reduce the risk of injury, never
place cutting blade or discs on
base without first putting bowl
properly in place.
25. Be certain cover is securely locked
in place before operating
appliance.
26. Do not attempt to defeat the cover
interlock mechanism.
3
IMPORTANT SAFEGUARDS