VDO Dayton TR 7327 B - Manual (Page 18)

19
Eng
lish
GENERAL OPERATION
General
Switching On / Off
To switch on the headunit, short-press the
knob.
To switch off the headunit, long-press the
button.
Selecting a Source
Your headunit is designed for different types of
sources, depending on your headunit model.
TUNER
SD/MMC
USB
AUX
BLUETOOTH
Short-press the button to change the source.
If the external media, e.g. SD card, is connected
or inserted, the corresponding source will be-
come available for selection.
SOUND
SOUND Menu
You can select the different sound settings from
the SOUND menu.
The following options are available in the below
shown sequence:
Volume
DSP
Bass
Treble
Balance
Fader
Loudness
To navigate the SOUND menu:
Short-press the button to select the
required option.
Turn the knob clockwise or counter-clock-
wise to select the option.
Note: The headunit will automatically exit the
SOUND menu after 6 seconds of inaction.
Option Setting
Repeatedly press
(turn the knob)
VOLUME
Range between 0 and 31, in
steps of one.
DSP
OFF, FLAT, CLASSIC, POP,
ROCK
BASS -10 to 0 to +10
TREBLE -10 to 0 to +10
BALANCE -10 to 0 to +10
FADER -10 to 0 to +10
LOUDNESS OFF, BB1, BB2, BB3
Mute (silence)
When the headunit is switched on, short-press
the knob to mute the sound. If a media (e.g.
USB or SD/MMC) is playing, it will be muted.
Short-press the same knob again to un-mute the
sound and the media will continue playing.
Note: Turning the volume knob to ‘VOLUME
0’ will also mute the sound, but if the current
source is USB or SD / MMC, the media will con-
tinue playing in the background.
Equalizer function
Press the button on the headunit or SOUND
button on the remote control to select one of the
programmed equalizer settings.
Flat
Classic
Pop
Rock
Off
Balance
To change the balance between the amount of
sound output on the left and right side.
Short-press the button to select the
sound control Balance (BAL).
Turn the knob to adjust the level of sound
output to the left and right speakers.
Bass (only when DSP is off)
To change the enhancement of low frequency.
Press the button to select the sound
control Bass (BAS).
Turn the knob to adjust the level of bass
enhancement.
Treble (only when DSP is off)
To change the enhancement of high frequency.
Press the button to select the sound
control Treble (TRE).
Turn the knob to adjust the amount of
treble enhancement.
Fader
To change the amount of sound output to the
front and rear speakers.
Press the button to select the sound
control Fader (FAD).
Turn the knob to adjust the level of sound
output to the front and rear speakers.
1.
2.
1.
2.
1.
2.
1.
2.