Vivitar 990HD - Manual (Page 7)

7
EN
Section 2
Getting Started
Loading the Battery
Before using the camera, you must load the Lithium-ion
rechargeable battery come within the package.
1. Insert the battery according to the correct polarity marks
( + or -).
2. Close the battery cover firmly.
Charging the Battery
You must use the supplied AC charger or the USB cable. The camera must be
turned OFF. The blinking light confirms the camera is currently charging, and
the light becomes constant after the charging is completed. In AC charging
Mode, the light will turn itself off automatically after 3~5 minutes . The full
charge time is about 4 to 5 hours. (Actual charging time may vary. It depends
on the battery conditions.)
Inserting and Removing an SD Card (Optional)
The camera comes with an internal memory that allows you to store
photos and videos. You can expand the memory capacity by using an
optional SD memory card.
1. Insert the memory card into the slot. Please refer to the figure on
the right side.
2. To remove the installed SD card, press the card inward to release
it.
3. When the card pops out, gently remove it from its slot.
4. Recommended memory capacity: 1GB or above.
Note
• When a memory card is fitted, videos/photos are saved to the card rather than the built-in
memory.
• Protecting Data on an SD Card: SD Card is read-only
when it is locked. No photos or videos can be recorded
when the SD card is locked. Make sure the lock is on
the writeable position before recording any media.
Writeable
position
Write-Protected
Position