Vidikron VERSION 50 - Manual (Page 19)

19 Vidikron Vision Model 50 Owner’s Operating Manual
Installation
Remote Control
To remove the battery cover, press in then pull up the small plastic clip holding the cover in
place. Install the two AAA batteries with the correct polarity and then replace the cover.
About the Batteries
• Make sure that the battery polarities are correct when installing the batteries.
• Do not mix an old battery with a new one or different types of batteries.
• If you will not use the remote control for a long time, remove the batteries to avoid
damage from battery leakage.
About the Remote Control
• Make sure that there is nothing obstructing the infrared beam between the remote
control and the IR receiver on the projector.
• The usable range is up to 8 meters (26.25 feet) within a 45-degree horizontal angle
and a 15-degree vertical angle.
• If the effective range of the remote control decreases, or it stops working, replace the
batteries with new ones.
• The remote control may fail to operate if the infrared remote sensor is exposed to
bright sunlight or fluorescent lighting.
• Ambient conditions may impede the operation of the remote control. If this happens,
point the remote control at the projector, and repeat the operation.
• The Ø icon appears on the screen when a button for an unavailable function is
pressed.