VIEWSONIC WMK-005 - Manual (Page 10)

WMK-005
Page 10 Installation Manual
Bracket Installation
NOTE: The two-piece mounting barrels are designed to allow for the positioning of each leg around
projector air vents located on the base of the projector. Where applicable, each leg mount may
be shortened by removing the locking screw. This will allow for a better bracket fit, overall.
NOTE: For easier installation, the mounting legs should be first mounted to the projector. Each leg
should then be adjusted so that they can mount to the Universal Mount (Figure 3).
1. Locate the mounting points on the bottom of the projector and use the appropriate number of
mounting legs.
2. Select the mounting hardware that the projector requires and loosely install the universal mount on
the projector.
Figure 3. Bracket Installation
Two Piece Leg
B
One Piece Leg
C
Inverted
Projector
Leveling
Barrels
M5 Allen
Wrench
M6 x 12mm
Hex Head
Screw
M5 x 12mm
Hex Head
Screws
M4 x 12mm
Hex Head
Screws
Universal Mount