VIEWSONIC WMK-005 - Manual (Page 11)

WMK-005
Installation Manual Page - 11 -
Leveling the Mounting Bracket
CAUTION:
Secure but do not over tighten the mounting hardware. Failure to do so will result in
damaging the threads in the projector.
1. Rotate the leveling barrels to level the mounting bracket.
2. Position the mounting bracket so that it avoids most, if not all, ventilation points (including lamp and
filter access doors).
3. When the desired position is achieved, tighten the mounting screws to the projector and then tighten
the hex head leg screws with the M5 Allen wrench (Figure 4).
DOWN
UP
Figure 4. Leveling the Mounting Bracket
M5 Allen
Wrench
Level
Inverted
Projector
Leveling
Barrels