Vitek VT-1256 - Manual (Page 6)

6
ENGLISH
WATER SPRAYER
• You can dampen the fabric by pressing the
spray button (4) several times (pic.4).
• Make sure that there is enough water in the
water tank (11).
IRONING
• Place the iron on the base (8).
• Insert the power plug into the outlet
.
• Set the temperature regulator (10) to the
required ironing temperature
: “•”, “••”,
“•••”or “MAX” ( depending on the type
of fabric ), the (9) indicator will light up
(Pic.3).
• When the sole temperature (12) reaches
the desired temperature value, the (9) in-
dicator will go out, you can start ironing.
• After you finish ironing set the (10) regula-
tor to the “MIN” position.
• Pull the plug out of the socket and let the
iron cool down completely.
STEAM IRONING
For steam ironing set the temperature regula-
tor to steam using zone or “•••”or “MAX”.
The iron has an anti-drop valve, which
stops water supply, when the sole tem-
perature is too low it prevents the appear-
ance of drops out of the sole openings
(12). While heating or cooling down of
the sole (12), you will hear clicks of open-
ing/closing of the anti-drop valve it means
that the valve works normally.
• Place the iron on the base (8).
• Insert the power plug into the outlet
.
• Make sure that there is enough water in
the water tank (11), the indicator (9) is not
lighting.
• Set the temperature regulator (10) to the
required ironing temperature
: to steam us-
ing zone or “•••”or “MAX”, the (9) indi-
cator will light up (Pic.3).
• When the sole temperature (12) reaches
the desired temperature value, the (9) in-
dicator will go out, you can start ironing.
• Turn the steam supply regulator (3) to set
the intensity of steaming, steam will start
outgoing from the openings of the sole
(12).
• After you finish ironing set the (10) regula-
tor to the “MIN” position and the steam
supply regulator (3) to the off position.
• Pull the plug out of the socket and let the
iron cool down completely.
ATTENTION!
If during the operation steam is not constantly
supplied, check whether the temperature
regulator (10) is set properly and whether
there is water in the reservoir.
ADDITIONAL STEAM RELEASE
Additional steam release function is use-
ful when ironing folds and can only be used
at high ironing temperatures (when the iron
temperature regulator (10) is set to
“•••”or
“MAX” ).
• When the additional steam release button
(5) is pressed, steam will be vigorously re-
leased from the openings in the iron sole
(pic.5).
Note: In order to avoid leakage of water
from steam openings, press the addition-
al steam supply button (5) with 4-5 sec.
interval.
VERTICAL STEAMING
For vertical steaming can be used only when
the high temperature mode is used (set
the temperature regulator (10) to “•••” or
“MAX”).
•
Hold the iron vertically at the distance
15-30 cm from the clothes press the ad-
ditional steam release button (5) with 4-5
seconds interval, steam will be released
from the openings in the iron sole (12) (pic.
6).
Important information
• Vertical steaming is not recommended for
synthetic fabrics.
• To avoid melting the fabric, do not touch
the iron sole to the item while steaming.
• Never steam iron clothing that is being
worn as the steam temperature is very high
and it can cause burns. Use a coat-hanger
or a stand.
1256.indd 6 1256.indd 6 25.03.2010 11:37:20 25.03.2010 11:37:20