Dexter Laundry SWD EXPRESS - Dryer (On-Premise) - Manual (Page 12)

12
SERVICING THE DRYER
Caution: Label all wires prior to disconnection when servicing controls. Wiring errors can
cause improper operation.
Attention.
Lors des opérations d’entrien des commandes, étiqueter tous les fils avant de les
déconnecter. Toute erreur de câblage peut être une source de danger et de panne.
PREVENTIVE MAINTENANCE INSTRUCTIONS
Note: All procedures must be performed when dryer is not running.
Routine Non-Technical Maintenance and Cleaning:
Daily
A. Clean lint screens. Use soft brush if necessary. Failure to do so will slow
drying and increase temperatures throughout the dryer.
B. Check lint screen for tears. Replace if necessary.
Monthly
A. Removal of accumulated lint using a brush and vacuum cleaner.
1. Clean lint from lint compartment.
2. Remove lint accumulation from end bells of motors.
3. Vacuum the openings in the burner primary air openings.
4. Remove lint and dust from top of cabinet, burner housings and all other
accessible areas in back of dryer.
B. Place a few drops of light oil on top and bottom pivots of the loading door
hinge.
C. Grease bearings and shaft using pressure grease gun and lithium base grease.
Quarterly
A. Inspect door gasket for excessive wear.