Asus P5AD2 Premium - Manual (Page 53)

A S U S P 5 A D 2 P r e m i u m A S U S P 5 A D 2 P r e m i u m A S U S P 5 A D 2 P r e m i u m A S U S P 5 A D 2 P r e m i u m A S U S P 5 A D 2 P r e m i u m 2 - 3 1 2 - 3 1 2 - 3 1 2 - 3 1 2 - 3 1
1 6 . 1 6 . 1 6 . 1 6 . 1 6 . ATX power connectors (24-pin EATXPWR1, 4-pin ATX12V1) ATX power connectors (24-pin EATXPWR1, 4-pin ATX12V1) ATX power connectors (24-pin EATXPWR1, 4-pin ATX12V1) ATX power connectors (24-pin EATXPWR1, 4-pin ATX12V1) ATX power connectors (24-pin EATXPWR1, 4-pin ATX12V1)
These connectors are for ATX power supply plugs. The power supply
plugs are designed to fit these connectors in only one orientation.
Find the proper orientation and push down firmly until the connectors
completely fit.
• Use of an ATX 12 V Specification 2.0 -compliant power supply unit
(PSU) that provides a minimum power of 350 W is recommended
for a fully-configured system.
• Do not forget to connect the 4-pin ATX +12 V power plug;
otherwise, the system will not boot up.
• Use of a PSU with a higher power output is recommended when
configuring a system with more power consuming devices. The
system may become unstableor may not boot up if the power is
inadequate.
• When using an ATX 12 V PSU with a 20-pin power plug, make sure
that it can provide at least 15 A on the +12 V lead, and a minimum
power of 350 W. Use of an ATX 12 V PSU with a 20-pin power plug
is not recommended.
• The ATX 12 V Specification 2.0-compliant (350 W) PSU passed the
motherboard power requirement test with the following configuration:
CPU : Intel ® Pentium ® 4 3.6 GHz
Memory : 512 MB DDR2 (x 4)
Graphics card : PCI Express x16 Nvidia EN5900
Parallel ATA devices : IDE hard disk drive (x 2)
Serial ATA device : SATA hard disk drive
Optical drives : CD-ROM (x 2)
SCSI devices : SCSI card and SCSI hard disk drive
• You must install a PSU with a higher power rating if you intend to
install additional devices.
P5AD2 PREMIUM
®
P5AD2 PREMIUM ATX power connectors
EATXPWR1 ATX12V1
+3 Volts
+3 Volts
Ground
+5 Volts
+5 Volts
Ground
Ground
Power OK
+5V Standby
+12 Volts
-5 Volts
+5 Volts
+3 Volts
-12 Volts
Ground
Ground
Ground
PSON#
Ground
+5 Volts
+12 Volts
+3 Volts
+5 Volts
Ground
+12V DC GND
+12V DC GND