I-View IR-5MIPN42 5-Megapixels IR Bullet IP Camera - Manual (Page 36)

36
configured before you operate the IP camera over network. IPv4 and IPv6 are both supported.
Configure the NIC settings, including the IPv4 (IPv6) Address, IPv4(IPv6) Subnet Mask and
IPv4(IPv6) Default Gateway. Click Save to change the setting.
1.
If the DHCP server is available, you can check to automatically obtain an IP address and
other network settings from that server.
2.
The valid value range of Maximum Transmission Unit (MTU) is 500 ~ 9676.
3.
The Multicast sends a stream to the multicast group address and allows multiple clients to
acquire the stream at the same time by requesting a copy from the multicast group address.
4.
Before utilizing this function, you have to enable the Multicast function of your router and
configure the gateway of the network speed dome.
5.
If the DNS server settings are required for some applications (e.g., sending email), you
should properly configure the Preferred DNS Server and Alternate DNS server.
6.
The router must support the route advertisement function if you select Route Advertisement
as the IPv6 mode.
PPPoE: If you have no router but only a modem, you can use Point-to-Point Protocol over
Ethernet (PPPoE) function Click this button to enable the PPPoE function, Enter User Name,
Password, and IP address for PPPoE access, then Save to change the setting and exit the interface.
Device Port: If there is a router and you want to access the speed dome through Wide Area
Network (WAN), you need to forward the 3 ports for the IP Camera. Click this button to modify
the HTTP (Default is 80), RTSP (Default is 554) or Control Port number (Default is 60000) and